GLAM ROLL-BRIM HAT
Size: One size - approx. 22.5” circumference (unstretched)
by 11” high (unrolled) – will stretch to fit up to 24” head
100 yds. bulky weight chenille-style yarn in main
color (MC), plus 5 yds. in contrast color (CC)
in Caron “Glimmer” (85% acrylic/15% polyester, 49 yds/45 m per 1.76
oz/50 g ball) in color 007 Mango
Crochet hook size J/10 (6.00 mm), or size needed to
Gauge: 10 sts & 10 rnds = 4” in spiral single
crochet on size J/10 (6.00 mm) hook
Terms/Abbreviations: beginning (beg), chain (ch),
decrease (dec), hook (hk), increase (inc), loop (lp), remaining (rem),
repeat (rep), single crochet (sc), skip (sk), slip (sl), slip stitch
(sl st), yarn over (yo)
Hat is worked in one piece in spiral single crochet
from crown to brim. Do not join or turn at end of rounds but
continue in same direction throughout (see note below.)
Magic beginning ring: wrap yarn around finger once,
insert hook into loop on finger, yarn over and draw loop through, ch
number specified to begin round. Work first round over strands of
ring, encasing them. After first few rounds are completed, pull
gently on yarn tail to close center of ring.
Do not join or turn at end of each round, but continue in
same direction throughout. Use contrast yarn marker to note
beginning of rounds and carry it up as you work.
Rnd 1: Ch 4, join into ring (or use magic beginning
ring method - see Special stitches/Techniques); ch 1, work 6 sc in
ring, do not join, do not turn (6 sc). Place contrast yarn
marker to note beg of rnds and carry it up as you work.
Rnd 2 (inc rnd): Work 2 sc in ea sc around (12 sc)
Rnd 3 (inc rnd): Work 2 sc in ea sc around (24 sc)
Rnd 4 (inc rnd): *2 sc in next sc, sc in next sc, rep
from * around (36 sc)
Rnd 5: Sc in ea sc around.
Rnd 6 (inc rnd): *2 sc in next sc, sc in ea of next 2
sc, rep from * around (48 sc)
Rnd 7: Sc in ea sc around.
Rnd 8 (inc rnd): *2 sc in next sc, sc in ea of next 3
sc, rep from * around (60 sc)
Continue even on 60 sts until yarn is almost gone,
reserving enough for last round.
Last rnd: Sl st loosely in ea sc around. Join with sl
st and fasten off. Weave in all tails.
Roll up brim as shown.
Flower (make one or more as desired)
With CC, ch 5, join into ring; *ch 5, sc into ring,
rep from * 5 or 6 times, join with sl st and fasten off, leaving 10"
tail for sewing.
Sew flower(s) to side of hat in your choice of
Variation: For a smaller hat, stop increasing after
reaching 48 sts on Rnd 6. Work remainder of hat on 48 sts.
Copyright 2007, 2011 - Designs by KN - www.designsbykn.com
personal or charity use only. Do not duplicate pattern for